PiCON-OG Light Gun Holster with Spool

This is a holster designed for the PiCON-OG light gun.  It's still a “first draft”, but it has worked well for me in my installation--so far.  Please give it a try and offer any feedback you have to make it better.

  The holster is relatively simple, but it does have a few  features:

• The spool allows for an elegant way to keep the cable off of the floor when not in use.  If you're like me, light gun games are an occasional party trick.  In my situation, keeping the cable tidy, off of the floor and away from cats and children is a higher priority than instant access. 

• The holster can be pivoted for a preferred  pull angle. 

• Two holster designs-- one for left and one for right  mounting strategies.

• A GX16 panel mount connector.  This is optional, but if you've used the GX16 connector in your build, it's a nice way to attach your cable.  This design hides the connection, while still keeping things modular.

• TPU Insert.  This is also optional and provides a little bit of cushion and protection to the lens. If you don't have TPU, you might get away with PETG, but I have not tried it.  

For this build you will require the following:

x4 M3x5(OD)x6(L) heat inserts.  (Same as used for the PiCON build.) (Amazon)

x4 M3x10-12mm screws (Amazon)

x2 M6x20 FLAT head screws with nuts (Amazon)

x4 Wood screws to attach GX16 connector mount. Also, a 7/8" (22mm) drill bit.  I recommend a Forstner bit.

I typically avoid the use of heat inserts in my designs, but I figured if you've got the skill and tools to build a PiCON, you already have everything you need.

***Assembly***

Step 0 - Print parts as you see fit.  I chose ASA as my filament, but anything should work fine.

Step 1 - If using the GX16 connector mount, ,drill a hole using a 7/8" (22mm) bit.  Then, use four(4) wood screws to attach the connector.  

Step 2 - Align the spool and mark the location to drill the 2 holes for the M6x30mm FLAT head screws.

Step 3 - Install M3x5(OD)x6(L) heat inserts into the holster.

Step 4 - Glue optional TPU insert into place at the bottom of the holster.  (I used hot glue.)

Step 5 - This part is important.  Route your cable through the exit port between the spool and holster.  Using your hands, hold firmly in  place.

Step 6 - Fasten the spool to the holster with M3x10-12mm screws.

Step 7 - Attach spool to your desired location (Arcade?) using the M6x30 FLAT head screws and M6 nuts.

Step 8 - If you like a clean finish, snap into place the optional cover plates.  

Step 9 - Insert your gun and enjoy.