PAAR416 v1 Specifically for ATM gearbox
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
PAAR 15 by igniz remixed to use the ATM gearbox.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 592
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Bring your own ATM gearbox and charging handle. T piece is printed
Only tested with Chenghai
SX and LDT compatibility is not guaranteed.
Hardware Needed:
1x m5 rivnut for the buffer screw
6x m5 hex nuts for the handguard
2x m3 hex nuts for the handguard
2.5-3mm roll pin for the bolt catch
Everything that comes in the files is modified, do not try to use original PAAR parts to replace them. Everything else follows the original PAAR design. Gel barrels have a larger outer diameter so you'll need to modify the outer barrel designs.
The rear suffers from good old krycrack syndrome since the buffer screw no longer goes into the back of the gearbox. Suggested print orientation for the lower is now flat on the magwell. Supports very much required. See the attached picture for print orientation.
This is just a v1 to flesh out tolerances, if you are going to use this in any stressful way, you'll need to have some way for the lower to screw into the upper to ensure it doesn't split at the rear pin line.
Credit to meowcha and 苍苍 on grabcad for their ATM gearbox models.
I am aware the v1 handguard is too slim. Handguards for the 416 are usually inline with the front pin, but I am not planning on modifying the handguard for this version at this moment. V2 is going to be split like the orca and require a hoseclamp for the stock, which is where my attention will be.