Caravan Sullage Pipe Plug/Bung
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple 29.5 mm plug/bung to seal the ends of my greywater sullage pipe when its being stored to keep the smells in.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 150
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Smells from my sullage pipe during storage were a problem so I designed a simple plug/bung to seal each end when its not being used. Its 29.5 mm in diameter which fits snugly in my pipe. I printed it in PLA and flipped it upside down so it is orientated as per the picture on the build plate. As it is hollow I enabled supports and deselected “On build plate only” so it printed with internal supports. Depending on your bed adhesion you may want to print with a brim but I personally didn't need it for the 3 I printed.