1 / 3
eScooter Chain Holder/Kettenhalter (5cm pole-Ø/3cm chain-Ø) — zdjęcie 1
1 / 3

eScooter Chain Holder/Kettenhalter (5cm pole-Ø/3cm chain-Ø)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a "clamp-on" design chain holder for any escooter with a pole diameter of 5cm and a max chain width of 3 cm.…

Ocena
0 / 5
Polubienia
12
Pobrania
42
Wydruki
0
Wyświetlenia
567
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Please leave a ♥ Like if this print was helpful to you :-) 

This is a "clamp-on" design chain holder for any scooter with a pole diameter of 5cm and a max chain width of 3 cm. Holds the lock securely in place when not needed and also makes locking it on somewhere much easier.

You need:

  • ASA to print for outdoor durability
  • 4 x M4x20 screws
  • 4 x M4 nuts
  • Loctite (optional)

A good assortment to get started is something like this.

Print Settings

  • Rafts: No
  • Supports: Yes
  • Resolution: 0.2mm
  • Infill: 30
  • Filament: Prusament ASA Black

Depending on your printer, supports below the ring that holds the chain might make sense. Choose the infill to your liking, I would recommend at least 20 % - but going beyond 50 % probably doesn't make any sense either.

 

Category: Automotive

Tagi