Centauri Carbon Z-rod grommet caps/spacers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Caps/spacers to keep the grommets for the Z-rods in place, as they tend to work themselves out after a few prints.
- Ocena
- 5 / 5
- Polubienia
- 35
- Pobrania
- 148
- Wydruki
- 3
- Wyświetlenia
- 650
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I noticed the Z-rod grommets like to work themselves out, so I designed these caps/spacers to keep them in place. They have a 1mm cutout so it doesn't squish them to oblivion.
Optimized so that it does not interfere with the camera or homing. You do not need to adjust print area settings.
I applied some silicone oil to both the cutout and the grommet to reduce friction.
Recommended to print in PETG or better.
For the left side the slicer settings don't matter, for the right one use 4 walls and 100% infill.
Supports aren't really necessary, screenshot of recommended printing orientation is attached. You might need to tidy the grommet cutout a little with a knife.
Update 03/10/2025
Added a cutout slot to the left piece, since it was too tight for some and would tear the silicone grommet. It seems like the clearance can differ quite a bit from printer to printer, you may have to scale it slightly to make it a friction fit, or put something (like tape) on top of the piece.