Qidi X-Plus 3 Printhead Cover (Multi-piece)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Printhead cover for the Qidi X-Plus 3, split into multiple parts for a stronger finished product.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 184
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a multi-part printhead cover for the Qidi X-Plus 3. It has been remodeled to use multiple pieces assembled with M2 screws. It is based on the newest cover Qidi released, with the side fan and custom blower.
All parts have a nearly flat side for orientation on the print bed. This was modeled with a 0.4mm nozzle in mind. Supports are not needed for any parts.
This was designed to use M2 heatset inserts (I used the CNC Kitchen ones) for all but the fan mounting screws.
There are two additional holes for mounting the part cooling fan duct. These are helpful, since Qidi glues the factory duct to the fan, and I found custom ducts like to tilt out of position. To use, install your duct of choice, then use the holes as a guide to drill a 1.7mm hole. Then either use an M2x4 screw, or widen the hole and install a pair of heatset inserts in the duct. I recommend this duct by Hi_Im_Dave.
I also added two small tabs to install screws that tie the cover to the hotend carriage. This was added after I had an earlier version pop off midway through a print. To use these, drill a 1.7mm hole through them after installing the cover, and use M2x4 screws.
This model was developed in onShape, and can be found here.