Honda CBR300R Clutch Basket Holder Tool (fits CB300F, CB300R, Rebel 300)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clutch basket holder for Honda CBR300R / CB300F / CB300R / Rebel 300 – locks inner & outer basket to remove center nut.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 299
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a clutch basket holder I designed for the Honda CBR300R, but it also fits the other bikes that share Honda’s 286 cc single-cylinder engine. This tool locks into both the inner and outer clutch baskets. It stays solidly in place while you torque or break loose the center nut, even if you’re using an impact wrench.
I tested it printed in PLA at 0.2 mm layer height, 5 perimeters, 10 top layers, 8 bottom layers, and 20% infill. It held up fine for the job, but if you want extra strength or heat resistance, PETG or Nylon would be even better.
Confirmed fit:
Honda CBR300R (all years)
Honda CB300F
Honda CB300R
Honda CMX300 / Rebel 300
Possible fit (check your part numbers):
Honda CB250R
This tool is meant to hold the clutch still so you don’t have to improvise with straps, rags, or screwdrivers wedged in places they shouldn’t be. Just print it, drop it on the basket, and wrench away.