SSE18 (AEP) to Odin Airsoft Speedloader Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A quick remix from this SR25 adapter as I liked the bb retention of it https://www.thingiverse.com/thing:6320348 I did r
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 199
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A quick remix from this SR25 adapter as I liked the bb retention of it . I did print the SR25 version and it worked very well!
It's a quick rough remix so some side could have more polish but it works soooo xD
Tested with SSE18 Novritsch small and big mag
A quick list of elements you need, it differ from the original
- 1-3x 6mm Airsoft BB's
- 2x M3x16 Socket Head Cap Screw
- 2x 1" Long, 0.24" OD, 0.2" ID Compression Springs (Ex. McMaster 1986K365 or 9657K298)
Not sure what I used for the springs sooo I did buy a box of them, go check the original model for assembly!
From the author :
Assembly Instructions:
1: Insert a 6mm BB into the hole on the short, angled side of the adapter. This is your stop ball, it will protrude into the BB feed path slightly when a spring is behind it.
2: Follow up with one of the springs, then another BB.
3: Insert a suitably long tool to drive the BB/Spring/BB down until the BB in the back clears the screw hole in the long side of the adapter - you'll see the BB pass by.
4: Drive in the M3x16 screw until it touches you tool, and make sure the BB is ahead of it. This keeps the screw away from your spring. Remove the tool and continue driving the screw until hand tight.
5: Insert a BB, then a spring into the magazine latch pocket's circular spring hole.
6: Insert the magazine latch with the large nub towards the Odin side of the adapter, then drive in the M3x30 screw from the side pocket, being sure that you pass the screw through the hole in the latch without clipping it. This needs to pivot freely! As a note, if you don't like the magazine retention force, you can use springs with smaller ID's (thus higher wire gauges) for more force. I find that the springs listed are enough to keep the magazine from falling out, and that's really what I was after. Do not use stronger springs in the stop ball hole. Too much force will make loading unpleasant.
For printing, print the adapter as-imported. Use tree/organic supports and set the angle threshold for 75 Degrees. This minimizes the number of supports needed, as the model is optimized to keep overhangs to an absolute minimum.