"Kirigami" "Parachute" Model
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This was inspired by the work of Polytechnique Montréal. They didn't share a model, so I made something printable.
- Ocena
- 0 / 5
- Polubienia
- 74
- Pobrania
- 313
- Wydruki
- 1
- Wyświetlenia
- 3824
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Engineering
- Licencja
- Creative Commons — Attribution — Noncommercial
This is pretty basic and probably has too many holes but it kinda works, so here it is.
Tips for printing: I had better luck with flexible PLA than with TPU, mostly due to stringing. I'd really like to print it thinner, but I needed 3 layers for wall adhesion and enough strength to peel off the bed without ripping.
I also adjusted my extrusion widths carefully (assuming 0.2mm layer height).
1st layer: 0.9mm
Perimeters: 0.9mm
3rd layer only (modifier required) external perimeters: 0.9mm
This will give you a “brick” style stack of layers for the mesh portion where the 2nd layer binds the bottom layer together and the 3rd layer is just a bit of extra insurance/integrity.
Be sure to check out the write up and video from the source. 👍