120mm Fan Bracket Honeycomb - DIY Activated Carbon Air Filter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adds 40mm worth of honeycomb manifold in front of a 120mm PC cooling fan to be used for a DIY activated carbon airfilter
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 155
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Public Domain
Designed to add 40mm of honeycomb manifold on to a standard 120mm PC cooling fan. I use this honeycomb manifold to pour activated carbon into for a DIY air filter on my cat's litter box enclosure. It works surprisingly well and the activated carbon is very cheap.
I originally got this idea from this youtube video but I improved upon it by making a printable carbon honeycomb manifold instead of the method shown in the video where a fan is sacrificed and boba straws are used.
Hardware:
- 8x M4 threaded inserts (go into this 3D print or skip this and use longer screws)
- 2x Steel mesh 120mm fan screens. I used these from Amazon
- 120mm fan of your choosing. I like this variable speed fan also on Amazon.
- 4x M4x12 flat head screws. Used to secure the outer fan screen to the printed part.
- 4x longer M4 screws. These will be used to mount and attach the fan to the printed part. The length depends on what you mount this too. The screws included with the fan were long enough for me to sandwich the interior fan grill, wooden mounting holes, fan, and interior screen to the printed part.
- Tape or glue to seal the fan screen
- Activated carbon. I just used some generic fish filter refill activated carbon
Assembly:
- Install heat set inserts into print. You could also use super long screws if you don't like heat set inserts.
- Attach the outer stainless steel screen to the honeycomb printed part using the short M4 screws. You can seal the edges with glue or tape. If you don't seal, activated carbon will leak out the edges when you fill it.
- Fill each honeycomb about ¾ full with activated carbon. Try to evenly distribute the carbon and don't pack every honeycomb all the way full. You still need air to pass through.
- Place the second stainless steel screen over the filled honeycomb to seal the activated carbon inside. Use tape to seal this side so activated carbon doesn't spill out.
- Place the fan on top of the screen you just replaced. Ensure direction of air flow is going through the carbon filter honeycomb.
- Place the sandwich on whatever you want to mount it to. For me, I just traced the fan outline on the cabinet I was installing this on and pre-cut/pre-drilled holes for mounting.
- Attach longer M4 screws through entire sandwich and tighten everything down.
Let me know if you have questions. I wasn't going to publish this so I didn't document the assembly super well. It should be pretty easy to figure out tho. Its just a big fan part sandwich with this 3D printed honeycomb manifold designed to allow air to pass through a DIY activated carbon filter. Works great on my cat's litter box so far.