3D Printer Emission Sensor Array (Sensorbox v2) Code Remix

I have used the two linked code bases to add some features to it.

They include the following:

• Wifi Icon in the top left. (Red if disconnected, green if connected) (only page 1)
• Time and date in the bottom right [DD/MM/YYY] (NTP enabled), autohides when Wifi is disabled to not have an error show. (only page 1)
• Added a text popup when turning on/off wifi to see if it actually did it. Same for saving the SGP30 Value baseline for reboots (no re-calibration needed)
• Added different brightness modes. 100%, 33%, 15%, OFF. Sensorbox defaults to 33% (bright enough)
• Edited button logic. Short/Single press = brightness, medium press = switching pages, long press = toggling wifi, very long press = manually saving the SGP30 value baseline with text popup IF the current values are in the safe threshold to not skew the baseline.
• Rearranged  the 2nd and 3rd page and swapped Pressure with Particles.
• Added an automatic save of the SGP30 Baseline every couple of hours that gets restored on reboot.

Button cycles:

Brightness = 1ms - 490ms
Switching pages = 500ms - 2000ms
Wifi toggle = 2200ms - 5000ms
Saving baseline = 5100ms - 7500ms

That's everything i can think of right now.

Update: Added a Gif to the gallery to show off the different brightness steps.

That gif seems to keep breaking once it played..