Koss Porta Pro Wireless Clips (2 versions)

I remixed the original to fit the Porta Pro Wireless 2.0. Mine original clips broke. I originally made the single piece version, but wasn't happy with how loose it needed to be just to fit together; so I made a 2-piece version.

For the 2-piece version: 

• This should use the same screws as the original piece. I lost mine, but was able to use some I had lying around.
• I printed this one in PLA .12mm layer height on an Elegoo Centauri Carbon. Print the files in the orientation they are in. No Supports
• Be careful not to strip the screw hole!

For the 1-Piece Version: 

• Printed in .12mm layer height on an Ender3 with wet PETG with no supports in the orientation of the files. If my printer can print it so can yours! 
  This is a very VERY tight fit and I had to make the pegs on one clips smaller. It took me several tries to get the fit to be loose enough to fit together, but tight enough to not fall apart.
• One of the sets of head bands is slightly bent at the very end to help stop the sliding mechanism. Slide the smaller peg clip past that point. Take the other clip and slide it into place over the bent piece. Next, take the other headband and slide it through the clip you just placed ensuring the holes of the bent headband are set in place. Then slide the other clip back and into position. The last part took some trial and error and I broke some clips in the process. Be patient and use the pictures I attached for orientation!