Medieval Obiwan sword
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My take on the medieval sword for Obiwan. It has a slot for a 5mm 3/16th inch rod for alignment/strength. I believe…
- Ocena
- 0 / 5
- Polubienia
- 91
- Pobrania
- 213
- Wydruki
- 0
- Wyświetlenia
- 1214
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
My take on the medieval sword for Obiwan. It has a slot for a 5mm 3/16th inch rod for alignment/strength. I believe 750mm or 1m is needed for the core. Should be printable without supports for all but the hilt guard which will need support.
This is not for commercial use.
Artwork by JakeBartok!
Update:7/8/2021 - Slot for rod was too large, I reduced the slot for a 5mm or 3/16th inch rod. It was originally actually 19mm. Thank you to the user who alerted me about this issue.
Time to print at 50mm/s at .28mm layer height with tree supports is 20 hours and 34 minutes using 191g of filament.
Category: Props