Bathroom Radiator Door Stopper/Blocker
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A doorstopper that can be clipped onto a bathroom radiator
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 56
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
We needed this practical and non intrusive door blocker to stop our bathroom door from opening completely, because the door handle would impact on a glass mirror.
Obviously this is preferable over drilling a hole into the tile floor, for a regular door stopper.
The bumper is angled to perfectly fit my door on contact. I can add a flat version if you like. Just leave a comment.
Printing Instructions:
I used PTEG for the base, with regular infill pattern at about 17-20%.
The bumper parts should be printed in TPU. Depending on how much infill you use, the bumpiness will change.
Try 13% and set 2 or 3 outer walls.
My TPU has quite a bit of shrinkage, so the bumper turned out loose. Might be better on your side.