1 / 1
Filament guide - Spool on the top and side of filament infeed — zdjęcie 1

Filament guide - Spool on the top and side of filament infeed

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Filament guide with two ball bearings, filament can be fed in the top and is angled 90° to the side. Screw to the wall.

Ocena
0 / 5
Polubienia
19
Pobrania
50
Wydruki
1
Wyświetlenia
668
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

I had problems with the filament spool unwinding to much because my filament spool holders roll so easily (suffering from sucess?). I therefore designed this filament guide that also angles the direction of the filament to the side directly into the infeed of the filament sensor on my Prusa Mini. Now everything is neat and tidy. 

The rollers use ball bearings, in my version I had the width-tolerance of the side plates a bit low so they don´t roll very easily but still good enough. This is updated in the current files.

I used 6000-series bearings because I had them on hand (10mm ID, 26mm OD). 

Edit: This is a remix for 608 bearings: https://www.printables.com/model/259008-filament-guide-spool-on-the-top-remix-for-608-bear

 You will need to make the axles youself!

You will need 4 screws 3*25mm (sides to back plate), 1 screw 3*15 (side plates together) and 2 screws to mount it on the wall (e.g. 3,5*20mm) plus two bearings.

Tagi