K1C Vibration Dampeners
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
K1C Vibration Dampeners
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 31
- Wydruki
- 1
- Wyświetlenia
- 236
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted to get rid of some more vibration on my printer because it sits on a very thin table. I put a solid concrete block underneath it and it made a HUGE difference. I had some left over clear PTU from a project that was getting quite old so I thought I would play around with some vibration dampening feet.
After about 30 different versions with many different version of infill I found this to be by far the best. The shape is pretty basic. Enough to widen the footprint but not take up too much space. The infil is where I found the magic to happen.
I did 3 layers of infill.
Bottom and top layer with 3 walls and mid part with 2 walls.
Bottom 5mm at 15% infill in Honeycomb. To give it a solid base.
Middle +-25mm at 10% infill in Gyrod. This seem to remove all the excess vibration.
Top at 10% infill in 3D honeycomb. To give it strength where the foot fits in and all the weight and vibration happens.
I then added a fussy skin outer to make it look a little nicer. Wasn't too fazed about that though.
This has worked GREAT from my setup. If you play around with different infills I would love to hear what worked best for you.