Spider Cobweb Windmill for Halloween

Cobweb Windmill

YouTube Short.

This is a 2-way spinning cobweb windmill with a themed tail-blade and a spider nut.

• Beautiful Windmill with a Halloween themed cobweb Propeller Design
• Self adjusting to wind direction through the Tail Blade
• 100% printed, no Screws or tools needed
• You can add 2 Propellers on one Axle with 2 distances
• 2 Propeller sizes are provided in the print profile, each which left & right spinning direction
• Choose your propeller sizes and directions (You get nice effects if you choose different directions)
• Rods are stack able to your needed height

Printing:

The rod could be a bit difficult to print, i added custom support, but clean your buildplate and apply some glue.

Profile is tested with PETG & PLA 👍 Prefer PETG for Axle and Rod.

Optional 'closed' Tail-Blade on Plate 7 for better wind adjusting.

Tip:

You can smooth the axles if needed with sandpaper and you can smooth the bore with a D6 Drill and add some grease or oil for smooth rotating.

Info:

This Axle is for 2 propellers (10mm) and 2 distances (5mm each). You can also mount a single propeller with 4 distances.

My other windmills are fully compatible if you want to mix it up:

• Sunflower Windmill (2-Propellers)
• Toroidal Windmill (3-Propellers)
• Honeycomb Windmill (3-Propellers)
• Elliptical Windmill (3-Propellers)
• Spiral Windmill (2-Propellers)
• Raccoon Windmill (2-Propellers)
• CLAMP for Windmills

Assembly:

Thanks to all followers and don't forget the virtual handshake 👍 ….Happy Printing😉

Commercial license & more Stuff you can find here:

https://www.patreon.com/BamBamDesign/membership