Semi Smart PSU Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
a simple semi-smart PSU holderbracket for mounting on the Core One (105mm hole spacing).
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 92
- Wydruki
- 2
- Wyświetlenia
- 529
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed a simple semi-smart PSU bracket for mounting on the Core One (105mm hole spacing).
The bracket can be mounted at suitable locations on the Core One (plastic rivets with 105mm hole spacing). The model can be mirrored in the slicer to use other mounting locations on the Core One - the ventilation slots must always face outwards and be aligned with the ventilation slots of the PSU. Check beforehand!
The bracket is 250mm long and can be printed vertically in the Core One without supports. I have a shorter previous model of the PSU case, so it doesn't protrude from the bracket. The current cases are approximately 290mm long and therefore protrude approximately 40mm from the bracket. However, the depth and width have not been changed and should therefore fit. I've also designed a US version that's 10mm wider (but haven't tested it) – please double-check before printing that the dimensions and alignment are correct for your PSU case.
Of course, I'll also upload the STP file for custom modifications or remixes.
For mounting, only the tops of the rivets are removed – the bottoms serve as anchors for M2 screws, which hold quite well if not overtightened. M2.5 screws or very small wood screws might also work, but I haven't tested them.