Gridfinity Desktop Tweezer Holder 1x1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holds 9x pairs of tweezers without touching the tips.
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 18
- Wydruki
- 2
- Wyświetlenia
- 161
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
If you work with small electronic components, you are probably picky about the state of your tweezer tips; just one bad bump and you'll lose the ability to reliably grab 0201 parts, and the ship will definitely have sailed on the 008004 parts that we probably shouldn't even think about using anyway.
This model holds up to 9 pairs of tweezers without touching their tips, and it holds them vertically to save space in X/Y. The three front holes are 4mm in diameter, the other 6 are 6mm. All holes are 42mm deep (all the way through this 6U part).
This is a model that can be printed upside down, which allows you to keep the top either very flat, or nicely textured, depending on your baseplate. This is a relatively tall model, and you can reduce the tendency to tilt by printing the bottom third of the model with 100% infill (and the top two-thirds with 10% infill). Another way to do this is by inserting standard Gridfinity 6mm x 2mm magnets in the base.