Excalibur 4400 Dehydrator Rear Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement rear cover for the Excalibur 4400 Dehydrator; possibly others.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 32
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
I picked up a relatively busted Excalibur dehydrator for cheap to use as a filament dryer, and many of the plastics were damaged. This is a replacement rear cover, which optionally has space for a switch to be added as the unit has no method of fully turning it off by default.
This project is built with build123d; you can customise it from the source files. Note: the source link is to a specific commit used to generate these models; you may wish to look at the main branch to see if any changes have been made since this model was submitted.
Printing Notes
This was printed in Polymaker Polymax PC (Polycarbonate) as I expect it will get near temperatures which would deform PETG; I didn't test this fact, just assumed. The print can be made without supports using the orientations in the .3mf files. Note that this is not the orientation that they are exported from the source files. Even printed with an enclosure it warped considerably, but the final print was usable.