fishing rod hand wrapper tool v1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
here is a simple fishing rod hand wrapper tool with sliding guide.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 303
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
This is a compact and easy-to-build hand wrapper designed for custom fishing rod construction. It can be used with a swing tip or another type of tensioning rod at the top, though it also works fine without one.
The design uses a single M6 threaded rod to hold two thread spools—one on each side. In my build, I used two M6 bolts instead (since I didn’t have a threaded rod available), which required drilling an extra hole after printing. I also added bearings on one side, but these are optional.
Hardware Required:
1× M6 threaded rod
2× M6 nuts
8× M6 washers
4× springs (to fit the M6 rod)
2× M6 wing nuts (for spool tension adjustment)
4× curtain wire hooks or eyes (to guide the thread)
Print Settings (Ender 3 S1):
Layer height: 0.28 mm
Print speed: 70 mm/s
Supports: only for the internal overhang in the slider guide
Infill: 15% (could likely use less)
The wrapper runs smoothly and provides consistent thread tension, making it a simple and reliable addition to any rod builder’s setup.