1 / 6
2.5 inch to 3.5 inch HDD/SSD Drive Sled Adapter Superleggera — zdjęcie 1
1 / 6

2.5 inch to 3.5 inch HDD/SSD Drive Sled Adapter Superleggera

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Allows you to use a 2.5 inch drive in a 3.5 inch drive sled.

Ocena
5 / 5
Polubienia
10
Pobrania
61
Wydruki
1
Wyświetlenia
343
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Public Domain

I needed to install a couple of 2.5" SSDs in my Supermicro 6028R-E1CR24N server. The correct drive sled for the server is an MCP-220-00140-0B which goes for about $27 on eBay. So instead of buying 2 of those and being done, I spend a couple of hours and about $20 on threaded inserts to make a worse version. Hopefully this proves useful to someone.

Parts needed:

  • 3 or 4 #6-32 x 4mm threaded inserts

    • I only used 3 but there are provisions for 4

    • You could also use an M3 x 4mm insert, but I wanted to be able to use standard 3.5" HDD screws

  • 3 or 4 #6-32 3.5" HDD screws (or M3 if you chose to use M3 threaded inserts)

  • 2 M3 x 5mm 2.5" HDD screws

 

You could also probably eschew the threaded inserts altogether and just ram some M4-ish screws directly into the bosses.

I printed it in PLA with eSun (AKA Microcenter Inland) PLA+ as fast as my Creality K1 could go and it turned out fine. The thinness allows flexibility so it is easier to get the inserts in. 

The 3.5" drive sleds that came with my server have a small lip on the bottom which allows the 2.5" drive to sit on them, thus screws for that side aren't required. Your drive sled may differ so you might have to find another way to secure the side without screws.

In the end, it's a little floppy, but it went into the drive bay fine and since I don't plan on taking it in and out frequently, it should be adequate.

Print settings:

Filament: eSun/Microcenter Inland PLA+

Infill: 10% adaptive cubic