CAT Toy Excavator Repair Kit for Bruder 1517/01
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
“Dogbone” (or bucket linkage) Repair Kit for Bruder 1517/01 Toy CAT Excavator.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 283
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Somebody threw out this broken toy excavator. The only problem with it was a broken bucket linkage. It seemed quite an easy fix, so I gave it a try. It’s holding up for a couple of hours digging pebbles.
Part 1 is not an exact copy of the original part. It made sense to replace the pin with an actual screw for better durability. It did not yet fall out without a nut, but you might want to add one.
I also left out the little hook that‘s supposed to prevent the bucket from sliding off. Probably because my test print had such a good friction fit that I did not see a reason to reiterate. And I don’t think it would be durable with printing in layers.
Printing Instructions:
For parts that should have more flexibility and durability, I usually use PETG. But I have a few PLAs that do flex a lot before breaking.
Print both parts at 100% infill.
Part 1 needs to be printed on the side and with supports. Its not a nice model to print, but it worked.