Buddy3D Camera (For Core One) Privacy Cover

The wide angle lens on the Buddy3D Camera for Core One can see a bit outside of the printer. Especially after mounting the angle modification by @Jason. 

So I made these little covers that just pushes onto the lens of the camera, and covers the acrylic windows of the printer.
Exact coverage will vary since the cameras and mounting isn't identical, but It can serve as a remix base for you to get it spot on.

For example, after printing only the angle mod from Jason it looks like my angle and coverage differ a tiny bit compared to his. 
So I doubt this print will be 100% correct for you since there seems to be variations in the lens, the lens mounting etc. etc. etc.

It's just a triangular hole in the cover, so it should be very easy for you to modify the three corners to get the coverage you want.
There is a tiny single nub on the outside of the cover which serves as a starting orientation when mounting it to the lens. It should be facing downwards when pressing it onto the camera, then rotate to fine-tune.

With the angle mod by @Jason my results are like this:

Before:

 

Note stuff I placed to be visible: 
-An orange print and a box to the left standing next to the printer.
-Yellow smiley pillow propped up on the sofa to the top right (hard to miss..).
-White towel hanging on the sofa armrest with a filament spool on top, and another filament spool on the floor below it. To the right.

After:

 

Printed mine out of PETG and it fit well for me.
Depending on your filament and settings it could be too loose or too tight. Scale accordingly :)