New Nintendo 3DS Battery Extender for 5000mah battery remix/remodel. Og maker is: @blueasis_1050361
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of the New Nintendo 3DS Battery Extender. backplates covers didn’t fit, so I made this one as a solution for now.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 295
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I would strongly advise to use supports for this case and outer/inner Brim, if its stands on the two sides were it connects with your new 3ds. You also have to put supports on the latch/locking tabs (see picture with blue circles). If you dont do this your case most likely wont fully lockin with your new 3ds.
it takes about 4-6 hrs to print. This in my opionen will give you the best results when printing this way
If its laying on its backside it doesnt need support, but it will most likely get elephant feet. Because of this the case might not sit as comfortable in your hands. The print time will be less dough 1hr plus.
I would advise against using supports for the stylus poort, even if your printer says that it needs it. Its difficult to get it out. I used a bambu lab a1 mini and it Printed out the case without using support for the stylus poort without a problem.
