Goosky S2 Tail Boom Cover

I designed this tail boom cover specifically for the Goosky S2 to enhance visibility during flight. Made to seamlessly mount with the factory screws, it significantly amplifies visibility in the air. Through rigorous testing, I've confirmed no adverse effects on battery life or 3D performance. THE MODEL MUST BE PRINTED WITH ONE WALL AND NO TOP OR BOTTOM LAYERS. It must also be printed standing vertically. I used a 0.24mm layer height with a 0.4mm nozzle. I also switched the colors multiple times so that I could get the striped look. Once printed you must remove the tail motor and the tail fin as well as the front bolt on the side of the tail blade so that you can slide the part over the tail motor and boom. Once slid on, the tail fin and motor must be put back on first, then the two lower bolts in the rear of the tail boom mount can be removed and replaced to secure the cover. Finally, the hole for the front screw on the side of the tail blade will need a hole drilled so that the last screw can be put back in.