Funnel for 5L Canister

Funnel for 5L Canister:

A pouring aid for a 5L canister into smaller containers, either through another triangular funnel, or directly into a smaller container if the neck fits into it (the outer diameter at the outlet is 17 mm).

◦ Two versions of funnel lengths: 16.6 cm and smaller with 15.1 cm

Thread pitch in the lid:
◦ 3 mm per turn

Non-printing necessary accessories:
◦ Rubber o-ring or hair tie as a seal (insert seal into the lid on the funnel neck. It is possible that this will work without the seal, but I have not tested on full load without it).

Recommended Print Settings: 🖨⚙
◦ Material:                PLA, PETG, ASA
◦ Nozzle diameter:  0.6 mm
◦ Layer height:        0.2 mm (bottom lid with thread), other (neck) set with "Height range modifier" to 0.3 mm
◦ Perimeters:            2 (with 0.4 nozzle use 3 perimeters)
◦ Infill:                       Honeycomb at 30%
◦ Print speed:           ~ 30 mm/s
◦ Brim and Skirt:     With ASA, print with inner and outer Brim
◦ Print orientation:  As in STL files
◦ Support:                No

Setting the "Height range modifier" in PrusaSlicer:
First in slicer, select your a common print with a layer height of 0.3 mm, then right-click on the model and select "Height range modifier" from the menu → In the modifer set the layer height to 0.2 mm and adjust the height of the range itself (from zero to the height you need).