Sklipps - Ski Mounting System
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Easy to print wall mount for cross-country ski. Utilizing the flexibility of the skis to easily mount and unmount.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 136
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Winter Sports
- Licencja
- Creative Commons — Attribution
Sklipps™ is an easy to print and use wall mounting system for your cross-country skis. No support, easy printing and no visible fasteners. The system utilizes the flexibility of the skis to lock themselves in place. When pressed together, they can easily be mounted and unmounted from the brackets.
Printing instructions
For reference I am using a 0.6mm nozzle with 0.3mm layer height. Adjust according to desired look.
Print time: around 2 hours.
- PLA/PETG
- No support
- 3 walls
- 4 top and 3 bottom layers
- 15% infill
- Use brim if needed
Installation instructions
One installation requires 1x top bracket, 1x bottom bracket and 2x universal mounting clips. Hardware needed is 4x 3mm countersunk wood screws.
- Fasten the clip of the bottom bracket to your desired height above ground and mount the bracket
- Lean the skis on the bottom bracket and check in what height the top bracket should be mounted to easily mount and unmount the skis
- Leave a mark under the bracket to see where to mount the clip
- Fasten the clip of the top bracket and then mount the bracket
Happy printing!