IFlight XL5 BN-880 GPS holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
IFlight XL5 BN-880 GPS holder An absolutely minimal mount that wraps around the GPS pcb and is being held by the two…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 414
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
IFlight XL5 BN-880 GPS holder
An absolutely minimal mount that wraps around the GPS pcb and is being held by the two rear bolts.
Print at 0.2 layers, 0.4 nozzle using PETG or TPU96+.
After printing open the arms of the support and insert the lower pcb into the slot. The arms should wrap around the pcb and hold it tight.
Unscrew the rear bolts and push them into the support holes (these are press-fit) until the bottom faces are flush. Once screwed back in place the holder/gps is fully locked.
Category: R/C Vehicles