HiKOKI System Cases Front Handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This MOD adds a Front handle on the HiKOKI System Cases
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 251
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Public Domain
I designed HiKOKI system case front handle referred from this model. https://www.printables.com/model/841950-makita-makpac-front-handle
It uses six M5 x 15 mm socket head cap screws and six M5 nuts.
The handle hinge is a common shape for both the left and right sides.
No Heat-Sets Required.
This MOD is confirmed to work with HiKOKI System Case Size 2 (M-size).
It may also be compatible with other sizes (1/S, 3/L, etc.) and Makita MakPacs.
I printed with Qidi ABS-GF,5 perimeters,15% (Gyroid),no Support.
<BOM>
6x M5 x 15 mm socket head cap screws
6x M5 nuts
6x Large-diameter washers :Larger than standard size is recommended to prevent damage to the case body
<Assembly >
Using the jig's holes (3.5 mm) as a guide, first drill pilot holes (approx. 3 mm) in 6 locations with a thin drill bit.
Using the pilot holes as a guide, drill the final holes (6 locations) with a 5 mm drill bit.
Place one side of the hinge over the case holes and secure it with 3 M5 bolts, using the (large-diameter recommended) washers from the inside of the case.
Insert the FrontHandle.stl into the hinge.
Place the other hinge part over the handle body.