Rigid Shop vac Hose Repair 2-1/4 inch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a repair for a Rigid 2-1/4inch shop vacuum hose.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 177
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
There is an internal part that slides part way into the hose after the damaged section is removed. The external sleeve/clamps are actually mirrored parts and are designed to accept a 5mm socket-head bolt and a corresponding insert. They have grooves that allow the ridges on the hose to set into. NOTE: once you push the internal part into the hose it will change the ridge pitch, you need to stretch the hose out to its free state so the grooves line up with the external sleeve.
Shop Vacuums seem to state their nominal hose size and the actual sizes vary. To ensure this model meets your needs I have included the specific dimensions as designed. Printers variations could change the as built size:
- OD of the cylinder that goes inside the hose 50.70 mm (1.996 inch)
The tool tip has a slight taper:
- OD of the tool tip 57.80 mm (2.275 inch)
- OD at the root of the tool tip 59.00 mm (2.323 inch)
You only need two Inserts, but this is what I used: 407pcs Brass Threaded Inserts for 3D Printing, M2 M2.5 M3 M4 M5 M6 Female Thread Metric Knurled Nuts Threaded Inserts Heat Set for Wood Plastic 3D Printer Interjection Molding: Amazon.com: Industrial & Scientific
Same with the bolts: https://a.co/d/gwNCC6W