Minimal Waveshare 7.5 in E-Paper Display Frame
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A minimal frame for a Waveshare 7.5-inch e-paper display, with mounting holes for a Raspberry Pi 3/4/5.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 78
- Wydruki
- 0
- Wyświetlenia
- 727
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a minimal frame for the Waveshare 7.5-inch e-ink display. The frame also has mounting holes to secure a Raspberry Pi 3/4/5 on the rear and a shield to protect the Pi and the e-paper HAT. There is also a stand to hold the frame when assembled. The frame is assembled using M2.5 screws. The fasteners required are:
- M2.5 x 6 screws x4, for the frame
- M2.5 x 25 screws x4, for the Raspberry Pi
- M2.5 nuts x2, to clamp the Raspberry Pi to the rear
- M2.5 washers as needed, to go on top of the shield
The parts assemble together in a straightforward manner. Just put the display in the frame, stack the Pi, eHAT, and shield behind the frame, and then screw everything together. The screw holes use the self-threading design created by Thomas Sanladerer, so no need for threaded inserts. The frame design takes some inspiration from the TRMNL e-ink display. The frame is small enough to fit on a Prusa Mini (each part printed separately).
If you are interested in my software for the e-ink display, you can check it out here.
Print instructions:
Print each part as oriented with 3+ perimeters to allow for enough material for the screws to thread. The stand can be printed with 2 perimeters.
Print settings:
- Material: PLA (or your preferred plastic)
- Layer height: 0.2mm (or above)
- Nozzle diameter: 0.4mm (or above)
- Perimeters: 3
- Supports: none