Tecnam P2002 Honeycomb Bravo Throttle Lever
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tecnam P-Mentor throttle lever for Honeycomb Bravo, realistic and ergonomic design.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 154
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This throttle lever is designed to replicate the look and feel of the Tecnam P-Mentor power lever, perfectly adapted for the Honeycomb Bravo Throttle Quadrant.
It provides a more realistic flight control experience, enhancing ergonomics and immersion for student and professional pilots alike.
The model has been precision-designed for 3D printing in PLA, with layer heights between 0.12 mm and 0.20 mm, ensuring both fine surface finish and structural strength.
All mechanical tolerances are optimized for a press-fit connection to the Honeycomb Bravo lever shaft, while maintaining ease of assembly.
Printing Recommendations
- -Material: PLA
- -Layer height: 0.12 or 0.20 mm
- -Infill: 25% (Gyroid or Cubic recommended)
- -Perimeters: 2–3
- -Supports: Minimal; recommended only for inner cavities or undercuts
- -Print orientation: Look pictures
Assembly & Finishing
- -The lever is designed for a press-fit on the Honeycomb Bravo shaft.
- -For a permanent installation, apply a small drop of cyanoacrylate glue.
Notes
This model was developed with accuracy and authenticity in mind, based on the Tecnam P-Mentor throttle geometry. It is intended for home simulator use only.
Enjoy a more immersive and realistic Tecnam cockpit feel in your simulator setup!