1 / 3
Tetra Ex 1200 - Air pump/Primer Cancel Cover — zdjęcie 1
1 / 3

Tetra Ex 1200 - Air pump/Primer Cancel Cover

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Primer cover to cancel it

Ocena
0 / 5
Polubienia
0
Pobrania
6
Wydruki
0
Wyświetlenia
57
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Pets
Licencja
Creative Commons — Attribution — Noncommercial

Hey everyone,

Me being a cheap guy, I had found a bargain deal on a tetra ex 1200 external filter (No, not plus. I wish it was), seller had lied about the condition of the filter as leak-free. These guys mostly leak due to the failed primer seals, and this one was no exception.It is a hard to find part. I also have an ex600 and fixed it with jamming a bunch of silicone and sealed the pump off that way. However this being a bigger model, silicone alone did not cut it. So I have scanned the part in my printer and traced it.
The part fits a little loose. If it's too loose for your liking, you may adjust the step file. Screw holes do match neatly and it covers the part. However I suggest adding some water resistand silicone under it to get the perfect seal. I have used two part glue (locally known as jalasanj/metal glue/arab glue) for the inner part and used Water resistant silicone on the outside perimeter before screwing it on to have a water tight fit.Which worked like a charm.
Now the filter only leaks from the main head gasket...
But how do you prime it now? Fill the cannister>Close the cannister>Attach outlet/inlet>Suck on the other end>Once the hoses have some visible water in them attach your pump and start it.

Do not use PLA, longterm it might degrade. 
I have used PETG. 
100% infill
At least 4 walls.
0.2
No supports

Tagi