FlashForge AD5M Top middle guard plate w/ more magnets and longuer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just a longuer version of this remix https://www.printables.com/model/1351891
- Ocena
- 4,75 / 5
- Polubienia
- 17
- Pobrania
- 139
- Wydruki
- 4
- Wyświetlenia
- 724
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I used this remix to create my own longer version (printable diagonally in one shot) that extends to the edge and passes under the screen. Be careful not to bend the screen cable; to avoid this, lift it slightly. )
This is a remix from a remix and great model that provides even more security for this front top cover with its six magnets. I only installed five because that's what I had left from the kit after installing the minimalist enclosure from @design8studio : https://www.printables.com/model/1130485-flashforge-adventurer-5m-ad5m-minimal-diy-enclosur
and side panels C and D, each with a magnet: https://www.printables.com/model/1259116-remix-of-guard-plateshttps://www.printables.com/model/1259116-remix-of-guard-plates
Because we don't use those behind the screen in this version, unlike in the official kit, so we have 5 left over.
Hope you will like it.
P.S.: If you encounter any issues with the length, please do not hesitate to let me know. Personally, it did not work in my first version ( a little to long by 0,3mm), so I shortened it on a V2, but then it was too short and left a gap, so I lengthened it again, but a little shorter than the first version and here is a V3 (with tolerence). However, I was unable to test it as I kept my shortened version of v2.