1U un-racked equipment end protectors
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Protectors I created for a Tripp-Lite PDU for use outside of a rack.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 21
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A business I help out with will set up a both at annual show events. As a part of providing power to the gear they bring they have a couple Tripp-Lite power distribution units (specifically model RS-1215-RA) that were salvaged from some decommissioned 19" server/telco racks. No rack is in use at the events, these just get carted in a crate and then set on the floor. For years the original rack mount ears had been left attached and were getting banged up, would get caught on things, and really just served no purpose.
I created these ends to mount in place of the rack mount ears. The goal was to have something that would provide a more gentle corner in the event you hit it and also just protect the unit a bit while it was sitting on the ground. The base side is wide enough that I put some 8mm button pads on it but I don't believe they're going to hold well. These protectors re-use the same screws that held on the rack ears. (On our gear someone was lazy and only installed 2 screws on each side to hold the ears in place. Sufficient, but would have been nice to have 4 per.)
These may fit other pieces of rack mount gear that have similar dimensions. Note that while I think the screw holes are supposed to be spaced at a specific, equal distance for this gear as I was doing my prototype prints I was adjusting the placement based on fit rather than trying to get measurements. Tweaking for your gear may be necessary; I'd print only one part and then test fit it wherever it will be used. In the end the same model was able to be used for both ends on two different Tripp-Lite PDUs with no tweaks between them. This should also provide a pretty good starting point for remixing for other equipment.
I printed these in PLA+ since I had the button pads to attach. If I were to print more I'd possibly try TPU to “rubberize” the whole unit. Printed on an AnkerMake M5 without supports or brim. Designed in Blender.
Like this model and want to give extra thanks? Consider buying me a beer! https://paypal.me/craigpow