1 / 7
Fan Shroud Panel for ITX Case to fit EVGA RTX 2070 Super card.  It stick out 1/4". — zdjęcie 1
1 / 7

Fan Shroud Panel for ITX Case to fit EVGA RTX 2070 Super card. It stick out 1/4".

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Fan shroud that attaches to the outside of my Silverstone SG13 case to allow the GPU to vent out the side

Ocena
0 / 5
Polubienia
1
Pobrania
4
Wydruki
0
Wyświetlenia
261
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

Had to cut a hole in my Silverstone SG13 SFF case to fit a RTX2070 Super card into it.  The fans stick out the side of the case so made the cover, shroud for the fans.

The 4 holes in the middle use the GPU cover screws to attach to the cards cover mounts inside.  There are 4 screws at the perimeter that attach the panel to the case from the inside.  These screw into the Panel with heated thread inserts( M3x4mm).

The grills or open rings friction fit into the holes.  I printed these in PLA-CF, they pop in pretty snug but could be glued.

Included step files so you can modify it to fit your fans.

The 2 screws inside hit the spot where the case shell slides into the front edge of the PC face.  I used very short flush M3 screws here and they allow it to slide in.

Tagi