1 / 7
Alternate Parts for PSX Armor Capsule for Rockman X (Mega Man) Kotobukiya Kits (v1.01) — zdjęcie 1
1 / 7

Alternate Parts for PSX Armor Capsule for Rockman X (Mega Man) Kotobukiya Kits (v1.01)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Details

This is an alternate build for the PSX Armor Capsule. Because we don't have source art for the capsule, my interpretation took some liberties. This version of the capsule might be more inline with what other people think the capsule might look like.

I originally wasn't gonna do this, but I decided to go ahead as it wasn't that hard to do. I learned a few new tricks while I was at it too.

Print Notes

Due to the use of support materials, some of the dimensions on certain parts had to be tweaked ever so slightly from the ideal fit in order to be inserted.

For the Capsule Tank Vents (x8), the Y Dimension (height if looking at it from the front) might need to be scaled to 97.5%.

Required / Optional Hardware

Four pieces of 4x1/2 Self Tapping Screws (or equivalent)
OPTIONAL Two pieces of 1.1"x1.6"x0.027" thick plexiglass, or equivalent (880971 from Hobby Lobby for example)
OPTIONAL Some glue might be required

Assembly

The instructions for this version and the original version should be more or less the same, with the only difference being the hose mount on the back of the module.

Refer to the original model upload for all the missing components and for final assembly.

Capsule Top Assembly Order:
1.) Using the attached decal print template, print and cut out one of the images of your choosing.
--The trick to this is to open it in Microsoft Paint. Open Print Preview. Then click Page Setup. Under Scaling, select Adjust To 100%. That will print as approximately to correct as Windows is capable.
2.) Sandwich the decal between two pieces of plexiglass and gently slide it into the Monitor Insert. Verify the image is centered.
--The Monitor Insert Alt.stl part can be used if plexiglass is not used. Using this part, just print a sticker and apply it to the plastic instead. The sides of the sticker will need to be trimmed slightly, however.
3.) Push the Monitor Insert assembly into the Capsule Top.
4.) Insert the Capsule Emitter Insert piece into the Capsule Emitter piece.
5.) Connect the Capsule Emitter to the Capsule Top assembly with a screw in one corner to tack it in place, then another screw in the opposite corner before screwing it down.
6.) Tighten the two screws then install the remaining 2 screws.
7.) The remaining upper assembly can be put together in any order. It is best to save the hoses for last.

Final Thoughts

If you build one, please post a make. I would love to see how they turn out.

Revisions

20260113 - I printed a version and made a few adjustments. The hoses do not snap in because the pegs are too short, so I increased the length of the rear pegs. I modified the Emitter Insert into two pieces so you can print the emitters any color and the black highlights in black. Finally, I made the insert for the monitor loose, so it can be inserted without being a tight fit. It will fall out, but it is held in place when screwing in the emitter.