Fast-Printing Toothbrush Holder (Vase Mode)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This (very) fast-printing toothbrush holder can be printed in around 40 minutes (2x version) or 65 minutes (4x version)
- Ocena
- 4,824 / 5
- Polubienia
- 209
- Pobrania
- 1009
- Wydruki
- 16
- Wyświetlenia
- 4226
- Oceny
- 17
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This (very) fast-printing toothbrush holder has been designed to print in vase/spiralize mode for quick printing times and low filament usage.
It has a simple and modern hexagonal design, and holds either two or four toothbrushes with no bottom underneath to allow for proper drainage. It also has a flexible back, which can open slightly to make cleaning the inside easy.
On an entry level printer, this only takes around 40 minutes (2x toothbrush version) or 65 minutes (4 x toothbrush version) to print.
I use a 0.6mm line width for increased strength. As this is designed to be printed in vase-mode, no supports are needed.
The design prints upside down (as oriented in the STLs), so please flip after printing.
I have uploaded a standard version and also a slightly wider version (for larger toothbrushes)
I hope people find it useful.
Enjoy :-)
If you find this useful, please check out my other designs on Prusa Printers and https://cults3d.com/en/users/LR3DUK/creations
Update: I have uploaded a version of the 2 toothbrush holder with a wider base (increased diameter by 10mm) to increase stability for larger toothbrushes (Filename:ToothbrushHolder_DoubleWider2). The STL can be easily scaled in the slicer to increase the size further if needed.