SKPOP Card Dispenser & Vending Machine Mini Ver. - REMIX

Updates

These are the changes I made to the instructions:

1. I changed the part numbering to match the part splits.
2. I added some steps for the new parts needing glued together and pushing out the deliberate support in the mouth of the body.

Pictured prints used these settings:

• 10% infill
• 0.20mm layer height
• Scarf seams on the gears, and cylindrical parts
  • Or at least random, to keep gears from binding
• Variable layer height on the Lid to keep the top nice and smooth
• NO generated supports needed

Here are the otherwise same instructions from the original post on Makerworld:

---

Description

The SKPOP Card Dispenser is designed as a k-pop photocard vending machine. The dispenser reliably dispenses 1 card at a time with the turn of a knob. Use it as your own “lucky draw” machine, or simply a playing card dispenser! 

• Works for 55x85mm cards and standard sleeves (for size limit, see tray dimensions below)
• Adjustable to work with sleeved/unsleeved cards of various thicknesses
• Larger original version here: https://makerworld.com/en/models/1882883-original-skpop-photocard-vending-machine#profileId-2016286

Measurements

📐 Overall Dimensions: 116 mm Height * 128 mm Depth * 97 mm Width
📏 Card tray internal dimensions: 62 mm Width * 95 mm Length

Components Required

You will need the following non-printed components:

• 6x M3 screws, length between 6 and 12 mm (Alternatively, use superglue)
• 1x rubber strip, length = 115 mm (for 36mm diameter roller drum), width ~ 15 mm, thickness ~ 2 mm; 
  Example: https://a.co/d/czWigbg (Alternatively, use rubber band)

Assembly Instructions

Link to instructions with images: https://sakupop.notion.site/Photocard-Dispenser-Mini-Assembly-Instructions-26edb1b586338023a395f527ab29e310

1. Insert main gear [10] through the case
2. Glue [7] front roller peg into [6] front roller (it's a tight fit).
3. Install knob [5] onto the gear axle from the outside of the case, then secure with a M3 screw.
4. Insert roller gear [9] through roller gear mount [8] into roller drum [4], then secure with a M3 screw.
5. Install the roller assembly to the bottom of the card tray [3], then secure with a M3 screw.
6. Pull the support out of the mouth on the [2] case.
7. Snap front roller [6] into card tray [3]. The front roller should not rotate freely. Make sure the two notches are pointing up.
8. Install the card tray assembly into case [2], then secure with 3x M3 screws.
9. Slide on lid [1] and dispense!

Adjustment for different card types

• To use with unsleeved cards, or if multiple cards come out at once, adjust by rotating the front roller [6] 90° so that the notches point sideways. This decreases the dispensing gap to accommodate thinner cards. Rotate more (up to 180°) if needed.