Kenworth 963 Bed
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An upgrade to the original bed
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 187
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an upgraded bed for my Kenworth 963 model. It’s now wide and long enough to fit two 1/10-scale crawlers side by side, and it also includes sliding ramps so you can load 1/18-scale crawlers on the ramps as well.
For the sides and back of the bed, I recommend using 5 mm × 450 mm rods — you can get them here: https://amzn.to/42MsZ0E.
It also requires eight 50 mm-long sections, which can be made from the offcuts of the five rods.
Just a heads-up — the link above is an Amazon affiliate link, so I might earn a small commission if you pick something up through it (at no extra cost to you).
Special thanks to Black Crow (Rocky Top) for all the help