Spatula (dual material)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A specialized spatula
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 88
- Wydruki
- 0
- Wyświetlenia
- 421
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
Oxo, made an awesome spatula that was perfect for use with stand mixers (notably KitchenAid), but has since dropped it in favor of a new design which is terrible. The old version is impossible to find (many have tried), so I took on the challenge of replacing it with a printed version. getting the right stiffness was difficult, but after many attempts this seems a good replica of the original. Printed with throughout using stock PET-G settings at 0.20 layer thickness and a 50% infill, the base layers are PET-G (1.6 mm) followed by TPU (1.4 mm) then switched back to PET-G for the rest. (the .3mf file has the settings)
Layer thickness was ramped down to 0.11 at the "neck of the spatula (around 2.77 mm) to add support at the point of highest flexure.
(The high infill seems necessary to prevent delamination)