MGN12 SeeMeCNC Barbell Carriage for Delta Printer (D300VS and others)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
MGN12 carriages for SeeMeCNC's barbells. For each carriage you will need 4 McMaster M3 Heatserts…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 735
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
MGN12 carriages for SeeMeCNC's barbells.
For each carriage you will need
- 4 McMaster M3 Heatserts https://www.mcmaster.com/94180a331
- 4 M3x16 Screws (Mount to MGN12H car)
- 2 M3x20 Screws (Barbell)
- 2 M3x12 Screws (Belt Retainers)
- 1 M3x12 Screw (Bottom Stiffener)
- 7 M3 washers
This uses McMaster M3 Heatserts, 4 per carriage. Two for the barbell, one for the belt tensioner screw and 1 for the strengthening screw at the bottom of the block. https://www.mcmaster.com/94180a331
It should be a drop in replacement for the existing carriages on an Ultibots D300VS.
I used 750mm long MGN12 rails.
https://www.thingiverse.com/thing:3962350 is useful for aligning the rails when mounting them.
Also check out my Hemera mount that also uses SeeMeCNC barbells https://www.thingiverse.com/thing:4027625
Category: 3D Printer Parts