Telescoping PVC Collet - 1" to 1.5"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Collet-based system designed for telescoping 1" PVC pipe inside of 1.5" PVC pipe. Designed with center-mounting a…
- Ocena
- 0 / 5
- Polubienia
- 33
- Pobrania
- 176
- Wydruki
- 1
- Wyświetlenia
- 1107
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
Collet-based system designed for telescoping 1" PVC pipe inside of 1.5" PVC pipe. Designed with center-mounting a flight stick in mind, but should be usable for any application involving length-adjustable PVC piping.
Print Settings
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Infill:
30-100%
Notes:
Forcing cone and collet printed at 100% infill PETG.
Lower retainer and cap printed with PLA; multiprocess setup with ~35% infill for grips and 100% infil for threaded portions.
Models oriented as-exported from Fusion 360. Recommend 180 degree Y rotation of cap, collet, forcing cone for printing. Lower retainer can be printed as-is, but will require supports.
Post-Printing
The lower retainer includes two indexing tabs to prevent rotation. Dry fit to 1.5" pipe, mark, and then cut with either a saw or rotary tool to accommodate.
A shim is included to prevent wobbling. The number needed will depend on the length of 1" pipe used; they simply slide over the 1" pipe, so any number can be used. Two appear sufficient to eliminate nearly all wobble with approximately 12" of extension.
Category: DIY