1 / 6
Raiscube X-belt tensioner & Z-axis stress reliever — zdjęcie 1
1 / 6

Raiscube X-belt tensioner & Z-axis stress reliever

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

freemark's x-belt tensioner is great but the dimension for the hole doesn't fit Raiscube's stock x-axis idler bolt so…

Ocena
0 / 5
Polubienia
3
Pobrania
19
Wydruki
0
Wyświetlenia
253
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

freemark's x-belt tensioner is great but the dimension for the hole doesn't fit Raiscube's stock x-axis idler bolt so I designed this from scratch, using freemark's tensioner as reference.

These types of belt tentioner is great because it relieve the right side's Z rod from being pulled by x-axis belt, reducing the amount of layer drift (z-wobble) when printing.

BOM:

  • 2 M5x35mm or longer to push again the 2 x-rod.
  • 2 M5 hex nut to hold 2 M5x35mm bolt in place
  • A new belt because the current one you are using won't be long enough

Print it flat. You'll need to add support but it will make the part stronger.

If you are confident in your layer adhesion, you can print it upright. You won't need any support printing this way.

Please note that the holes for the Hex nuts have very tight tolerance, so you will need a pliers to force it into the holes. Alternatively, you can use a hot gun or a soldering iron to heat the nuts up when pushing them in.

Print Settings

Printer:

Raiscube R2

Rafts:

No

Supports:

Yes

Resolution:

0.2

Infill:

20%

Filament:

Chinese Generic PLA

Gray


Notes:

Support setting for printing on its side is Everywhere, 80

Post-Printing

Printed and prepared

Assembled

Category: 3D Printer Parts

Tagi