GIRO - TEVO Tarantula / 608 Ball Bearing Y-Axis Idler
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
GIRO - 608 Ball Bearing Y-Axis Idler General This idler was designed to be mounted on the Y-Axis of the TEVO Tarantula…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 373
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
GIRO - 608 Ball Bearing Y-Axis Idler
General
This idler was designed to be mounted on the Y-Axis of the TEVO Tarantula and uses 608 ball bearings. This idler is also usable for other printers with a 4020 extrusion profile as an axis. Please let me know if there are other printers where this idler also works. This Idler may be used with the stock Y-Axis carriage or other Y-Axis carriages by Mackers, Taralu or other manufacturers.
This Y-Axis idler is an addition to my designed 626 ball bearing X-Axis idler which is called GIRO - TEVO Tarantula / 626 Ball Bearing X-Axis Idler.
You will need additional screws, nuts and washers for the mounting of the idler. The needed parts are mentioned below.
Additional screws, nuts and washers
- 2x M3x35
- 4x M3 Washer
- 2x M3 Nut
- 6x M4x10 screw
- 12x M4 Washer
- 1x M5x35
- 2x M5 Washers
- 1x M5 Nut
- 2x 626 Ball Bearing
- Printing
I would recommend to use 2 or more perimeters. Print with a lower speed, for example 30 mm/s, to get a more accurate printing. I recommend to print the idler with at least 50% Infill for the bracket and 100% infill for the pulley and pulley insertion.
Additional Information
Let me know if there are any kind of problems with the idler. I will try to help and if neccessary correct the designs. I appreciate any kind of feedback to this idler.
If you like my work and find it really usefull then I would be very happy if you give me a small tip as an appreciation for my work.
