Clock Winder for 3D Printed Clock
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a clock winder I made for "Clock 45" from Brian Law's Wooden Clocks.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 502
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution — Share Alike
This was created to add to my Clock 45 from Brian Law's Wooden Clocks. It needed a winder so here you go. The square key hole on the winder is 4.6mm wide and 11.75mm deep.
Total print time is about 2:30
Filament: PLA
A raft is recommended as these are pretty small.
Supports:
You should not need supports for the Barrel and Knob if printed vertically and you use a raft, but the Arm will need supports if you do not print it on it's side.
Hardware:
2x - M3x10 Screws
When fitting the knob to the arm, leave it a bit loose so the knob will spin.
This model is open and available to the public on TinkerCad here: https://www.tinkercad.com/things/9CYt2KKoTQs-clock-winder-v1-0
Happy Printing!
You can help
To help cover the expenses of printing prototypes for the models I share, please consider a donation by purchasing an item from my Amazon wishlist here
Please leave a comment and let me know how you like this model.
Also, if you like this model, check out my other models over here:
https://www.printables.com/social/130916-hendersons-handcrafts/models
Below are just few of my other models |
 |