223/300blk case soft jaws for Vise-Grips
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Soft jaws for Irwin 7WR Vise-Grips to hold 223/300blk brass cases during reloading tasks
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 192
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Why:
Bulk converting to 300blk would hurt my fingers for days after because I would do the final trim using a FA trimmer and very little case would stick out to hold onto. So I wanted some simple soft jaws to firmly hold the cases, indexing off the rear of the case reducing the fiddle factor and time. These only put pressure down by the web and rim of the case so no problem with deforming your case. Goal was to only add a few seconds to the final trimming cycle
Fit:
Meant to be a friction fit onto the jaws of the Visegrips so YMMV depending on your pair of 7WR's and printer. You could easily expand one of the sides and glue in a magnet if you really wanted an even slicker solution.
Filament:
Original plan was to print it in 95A TPU, but the friction fit onto the jaws works well and holds very well with regular PLA.
Print Notes:
100% infill = under 3grams
Files:
Uploaded STL and STEP if you want to edit. It's far from elegantly modeled, but all the geometry that is needed is there.