1 / 2
Pencil Banners
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Banners for pencil polearms to show your allegiance to your favorite subjects.
- Ocena
- 5 / 5
- Polubienia
- 66
- Pobrania
- 81
- Wydruki
- 2
- Wyświetlenia
- 758
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (8)Wydruki i komentarze (Wydruki: 2) (Komentarze: 5)Remiksy (0)Kolekcje (50)Powiązane
Satisfying to touch,
Satisfying to rattle,
Satisfying to declare your independence with them.
Printing:
- Banners:
- Use at least 2mm of brim or a full solid first layer under them!
- Use Z-hop (I used 1mm)!
- Decrease retraction length (I used 0.2mm for a direct drive).
- Decrease printing speed.
- Shaft:
- Use a brim (i used 5mm)!
- You might need to scale it up along the XY axis about 7-10% to ensure a tight fit (I scaled it up about 10%).
Be careful if you plan to remove the brims from the banner — the links break easily. I left them on and they are still very flexible.
Assembly:
You will need:
- A banner
- The shaft
- The banner pole
- The topper
Instructions:
- Slide the banner onto the shaft.
- Place the shaft with the banner into the banner pole.
- If you are using the nonslip pole, keep the 2 outer rings/links of the banner at the 2 edges of the shaft when installing it on the pole. This will prevent the banner shifting on the shaft left and right.
- Put the banner pole onto the topper.
- Arm any of your pencils with it — have fun!
Updates:
2025/10/26:
- Added a Nonslip variant of the banner pole. It prevents the banner moving on the shaft left and right.