QIDI Q2 minimalistic purge/waste bin (poop box)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Minimalistic filament purge container for QIDI Q2, requires no hardware (magnets, screws, etc.) to attach to the printer
- Ocena
- 5 / 5
- Polubienia
- 272
- Pobrania
- 4259
- Wydruki
- 23
- Wyświetlenia
- 7665
- Oceny
- 42
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Simple and easy to print filament waste bin for QIDI Q2. Unlike most other models does not require any additional hardware (magnets, screws, adapters, etc.) to mount.
The hook/latch design relibly holds the bin in place while still being easy to print even without supports - just clean some saggy perimeters inside the hooks after printing and you are good to go.
Comes in various pre-made sizes specified in the file name as DEPTHxHEIGHT, where 140 mm tall bin (almost reaching the surface the printer stands on) is the reasonable maximum to ensure that it is still convinient to tilt the bin for removal. STEP file is also included for those who want to use the hook/latch design but have a bin of custom size or shape.
Recommended print settings: any rigid filament except PLA (as it creeps under static load and probably not heat resistant enough), 0.2 mm layer height, 2 perimeters 0.5 mm each, Arachne perimeter generator, decent cooling and some slowdown for the hooks, no supports required. Otherwise whatever settings work for you, it is a relatively simple print.